Releasenotes

From bero*fix - professional SIP gateway

Jump to: navigation, search

Contents

Release Organisation

There are 2 kinds of firmware verions, Releases and Patches. The Releases are divided in Major and Minor releases. Minor Releases with the same Major will receive only security fixes and general bugfixes. Newer Major Releases might contain newer features. Between 2 Minor Releases there might be multiple Patch-Releases.

The Firmware Name for a Release is then

$Major.$Minor 

The Firmware Name for a Patch is then

$Major.$Minor$Patchlevel


This page will contain information about the current release and about the changes between each release, where the newest release is the most recent entry.

We try to release a minor release every quarter of a year and a major between 1-2 years.


1.12 - 08.06.2010

SIP Register @ SER works now
fixed some NT Stack issues (memleaks and performance optimization)
overall performance enhancements of SIP-ISDN-GW Software
added higher timeresolution for syslog prints
fixed summer time issue
some more isdn-sip signalling optimizations
some berofix API fixes
fixed bugs, that the channel id was not encoded properly for outbound calls
beroFix API supports a httpport setting
added allow_sip_183_without_sdp=1/0 to config string (0 -> proper alerting signalling with asterisk and snom)
ignorep8=1/0 to config string (ignorep8=1 -> proper early audio)
Paying attention to the Port when receiving a SIP Moved temporarly (302)
Fixed Timer in TE Stack (start T305 after expiration of T313)
check for clir_on_sip when "d:" is used in dialplan
disabling Echocanceler when Faxtone is detected (and T.38 is disabled)
added syslog Facility setting
allowing "-" and "." in SIP Names/usernames 
added 3CX Wizzard
added regrefresh  (Registration refresh) option
using clir_on_sip as displayname for inbound setups with CLIR (or empty OAD)
added reset (sr) of callstatistics in telnet Interface
speed up "bc" in telnet interface
DTMF with letters a,b,c,d work now
added wait_for_cancel=1/0 Config string option (default 1, supports early audio for not successfull calls, eg. cause:1 unallocated number)
added proper overlapdial for ISDN-ISDN Rules
fixed some config-string ("more") issues in GUI


1.12rc10 - 12.03.2010

Fixed 2 major deadlocks which made berofix not accept new incoming calls on high inbound call traffic
Restructured Frontend in the Management/ Settings Area
Provisioning works now on TFTP & HTTP
added beroFos integration
fixed issue that the MTU was automatically set to 500 after a firmware upgrade, which resulted in several network problems
Partial Rerouting added (calldeflect on Point to Point Lines)
Fixed several ISDN and SIP issues 
Fixed several Frontend issues
Added IE on SIP which makes ISDN-ISDN Routing more efficient
NTP Protocol is now supported (instead of the old time protocol)

1.12rc5 - 01.12.2009

Hardware Bridging enabled between 2 Lineinterfaces
TFTP Provisioning enabled
ISDN-ISDN Routing in Dialplan
Calldeflection
and many more ...
More detailed release notes will we published when the 1.12 is released.

1.11zh - 30.07.2009

4S0 memory leak fixed
support for secondary callerid added (CLIP no screening or special numbers are send via displayname now)
send SIP Busy when received a ISDN busy cause (instead of unavailable)
added more locking to prevent a segfault that happens after about 100 0000 calls
fixed a general memory leak
fixed a memory leak when CRC errors or L1 State changes where received
fixed issue that not more than 64 bytes of D-Channel frames can be received with 4S0, for example setups with very long numbers
fixed bug for E1 that channels above and including channel 17 could not be used safely

1.11zb - 23.06.2009

IE Edit Bug fixed
Bridging Bug fixed
Overlapdial Timeouts can be configured again
Codecs and codec orders can be configured now
Personal tools